I found a red mahogany stain at Lowes and tried it out on a small sample piece which was cut from the same boards I was planning to use. Most of my mom's furniture is a reddish brown stain and I wanted this mirror to match. On the next attempt I made the box too big, and although it still works just fine you can definitely see where the monitor ends inside the box, and I had to add spacers to keep the monitor in the center.įor these reasons it can be a good idea to make your cuts very careful, allow one-half to one inch of extra space on your measurements and measure the box before you nail/glue/screw anything together! On my first attempt at a magic mirror made the box to small and ended up breaking the monitor trying to force it into place. Good fit! I could have made it a little smaller but this is fine. Below is my picture of the first time I put the monitor in the housing. My first magic mirror was running very hot with just the holes in the bottom, so I added a hole in the top and picked up some small fans to fasten to the hole and that helped tremendously.Īlways a good idea to do a "dry fit" to make sure the monitor fits how you want it to before staining/painting. The main features of the housing that I want to highlight are the ventilation holes on the bottom and the ventilation square on the top. They have all the tools you could ever need for woodworking, welding, laser cutting, electrical work.etc. If you're in DFW and need a place to do handy work like this they have a wonderful workshop. Shout out to the Dallas Maker Space where I put this together. This gives it a nice overlap to keep the mirror and monitor in place. I just used 3.5" x 0.75" boards for the main housing and 1.5" x 0.75" boards for the frame. The basic construction of the mirror housing is very simple. This is fine if you want to paint it or want a light stain, but pine does not take dark stains well at all.įor my Mom's magic mirror I used oak and had much much better results with staining, so be sure to pick a wood that will work well for the finishing that you have in mind. You can get actual glass if you want (it looks very nice) but it will cost more than acrylicįor my first magic mirror I used pine because it was cheap. I had much better luck with TAP Plastics, their mirrors are very high quality acrylic and each of mine cost ~$60. I tried ordering a cheap acrylic mirror from Amazon but the first and second one I got were cracked. 2 way mirror: This is one of the most expensive parts of the project.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |